Specification
|
Supply Voltage |
6V DC (230V AC version optional) |
|
Battery life |
5-6 years with low cost alkaline battery pack supplied |
|
Low battery action |
Buzzer tweets near end of life then disables valve opening when critical |
|
Motion Sensing |
PIR* with domed fresnel lens |
|
Detection area |
100 x 60 degrees beam width |
|
Detection range |
5m ahead, 2m at edge of beam. Optional reduced sensitivity setting |
|
Control valve |
Magnetically latching solenoid, 2mm orifice, 15mm compression fittings |
|
Max. water pressure |
12 bar |
|
Min. water pressure |
1m head; optional 4mm orifice valve available for very low pressures |
|
Fill time |
0-31 minutes, 1 second resolution |
|
Flush cycle time |
20, 30,40 or 60 minutes set via switches |
|
Maintenance flush |
None, 8, 12 or 24 hour intervals |
|
Manual flush |
Hidden button on front of unit gives instant fill, enabled or disabled via internal switch |
|
Battery check |
Hold down manual flush button to show battery state |
|
Visual indication |
A red light in the dome flashes once on manual flush and at start of each cycle |
*PIR - Passive InfraRed detection, an electronic device which detects movement of body heat.
A leaflet including the Smartflush specification can be found by clicking the link: Springwell Smartflush Leaflet
